Mandrel bent for 79-93 Fox Body Mustangs
-This goes from the muffler to the rear bumper.
-Aluminized or Raw 409 Stainless Steel (Special Order)
-Two piece design for easier installation and to allow installer to adjust pipe for perfect fit. This means it requires a clamp or welding above the axle and also at the muffler outlet. 
-Tip is left a little long so final length can be cut to your preference in length and angle. 
-Designed to go with the single exhaust systems listed below and is included with complete single exhaust systems. 
-Designed to use a Torctite clamp (below) but it can be welded as well (welding just removes adjustability and makes it non-removable without removing control arm or cutting the pipe).
-Driver's side installation only (Passenger Side Available Special Order Only).