Mandrel bent for 79-93 Fox Body Mustang and Capri

This goes from the mufflers to the rear bumper. We are the only manufacturer for 3" tailpipes specifically for these applications. The tips are left slightly long so they can be cut to your preferred length and angle to match your bumper cover.

• Aluminized Steel or raw 409 Stainless Steel (Special Order).
• Two piece design for easier installation and to allow installer to adjust pipe for perfect fit. This means it requires a clamp or welding above the axle and also at the muffler outlet.
• Tip is left a little long so final length can be cut to your preference in length and angle.
• Designed to go with the single exhaust systems listed below and is included with complete single exhaust systems.
• Designed to use a Torctite clamp but it can be welded as well (welding just removes adjustability and makes it non-removable without removing control arm or cutting the pipe).
• Driver's side and Passenger Side Available.