(97-04 Ford 4.6 & 5.4, 99-04 Lightning, 99-01 Cobra, 03-04 Mach 1, 03-04 Cobra, 97-04 Crown Vic, Gran Marquis, Town Car, Custom Apps, Engine Swaps, Coil On Plug Ignition Only) 

This harness is for 4.6 and 5.4 engines with coil on plug ignition system (not dual coil pack) swapped into older vehicles. You get everything you need for your engine to run like factory. Based on the Telorvek panel, the system allows you to install the computer just about anywhere in the vehicle. 
Here's how it works: The sensor connectors are factory installed to 20 foot lengths of wire. Once you plug the connector into the sensor, run the wires back to the Telorvek panel. The Telorvek panel has factory installed connectors to then plug into the factory computer. 
What this offers you: Installer chooses the location of components. Wires can be dressed for a neat, professional look. Simplified diagnostic troubleshooting.

Beginning with the 1996 Mustang and 1997 passenger cars, Ford began installing Passive Anti-Theft Systems (PATS) in their ECMs. Short of installing all the components and sensors from the donor vehicle, the only way to defeat PATS is by reflashing the ECM to completely remove it. We can perform this for you. During the reflashing process, we can set up your ECM for aftermarket fuel pumps and disable certain emission sensors if your local smog laws permit. These 4.6's are coil on plug (COP). The 4R70W, 4R100W and manual transmissions were used behind this engine. Other non-computer controlled transmissions can be used as well. 

Harnesses are drop shipped by Ron Francis via UPS ground service and most of them are made to order (not stocked) so immediate shipment is not expected.

-Download install instructions here: INSTRUCTIONS