Mandrel bent 3" Tailpipe for 83-88 Thunderbirds, 94-95 Mustangs, Lincoln Mark VII, & 78-83 Fairmont.
-This goes from the mufflers to the rear bumper.
-Aluminized Steel or raw 409 Stainless Steel (Special Order).
-Two piece design for easier installation and to allow installer to adjust pipe for perfect fit. This means it requires a clamp or welding above the axle and also at the muffler outlet.
-Current over-axle pipe design is multi-piece and welded prior to shipment.
-Tip is left a little long so final length can be cut to your preference in length and angle.
-Designed to go with the single exhaust systems listed below and is included with complete single exhaust systems.
-Designed to use a Torctite clamp (below) but it can be welded as well (welding just removes adjustability and makes it non-removable without removing control arm or cutting the pipe).
-Driver's side installation only (Passenger Side Available Special Order Only).