This lip prevents items stored above the lid from sliding out of the cubby during acceleration. The lip is designed so it does not hit the dash when the lid is opened. Attached to the lid with 3M double sided foam tape (included). Fits all 2020-2024 Ford Explorers.

There are 3 texture patterns available for the visible flat surface. Pictured is the raw carbon fiber geometric. Also available is a carbon fiber pattern and a simple textured pattern. Choose your preferred texture and color (silver pictured). 

If there is interest, we can make a version with an integrated slot to hold a Dragy. 

Be sure to check out our other Explorer ST dress up items (wheel cap and blue oval overlays, mirror ST logos, underhood brace logos, door scuff plate ST add-on's, etc.). 

Installation: 

• Clean the scuff plates well. Remove any road debris, dirt, wax, etc. Ideally you'd use an alcohol wipe or a light solution of dish soap to remove any oils for maximum adhesion. 
• Peel the the white backing paper away from the overlay and make sure the overlay stays stuck to the clear mask.
• Hold the edges of the clear mask so you can position the overlay without touching it. If you don't get perfect alignment initially, you can pull it back up if it's only stuck in the center. Once you've got it aligned where you want it, stick it down and then press from one end to the other to remove any bubbles. Now run your fingers over the letters with solid down pressure to maximize adhesion
• Now remove the clear overlay carefully to make sure it doesn't try to remove any of the letters. If it does try to peel them up, press it back down with firm pressure before trying again.